Deutsche Version Actually: English Version

Bar puller

setting up the jaws
  1. Setting the gripper jaws of the bar puller
  1. Gripper jaws >>Z<< measure
  2. Pull the bar ca. 70mm
    off the clamp
  3. Gripper jaws release
  4. Manual approach to ca. diameter
  5. Adjustment of the bar puller = diameter of the bar - max. 3mm
  6. Tighten the gripper jaws
  1. One set of gripper jaws for all diameters
  2. Steplessly adjustable
  1. Sample program:

    2. Workpiece length = 17 mm
    to pull out = workpiece length + parting steel = 20 mm
    the diameter of the bar = 50 mm

    1. G0 x 80 Z - 25 Approach in rapid motion
    2. G0 x 0 Position in X (diameter)
    3. M6
    		Release clamp
    4. G0 Z - 5 Pull bar
    5. M7 Close clamp
    6. G0 x 80 Take away the tool turret